As we move into the holiday season, we also experience a change in the weather. In most places in the US, the winter months mean that the climate inside most packaging plants change. With that, line operators need to take that temperature change into consideration when working with hot glue machines on their packaging lines.
Hot melt consistency, heated hose and gun temperature consistency and glue stringing are all potential problems that maintenance managers can deal with during the winter months. One of the most important things to look at is where your packaging line is located within your facility. Most melters are located at the end of the line, which leaves them close to an exterior wall, door or window. The cold temperature outside could be impacting, not only the viscosity of your glue, but the heating time of your glue and its adhesion ability. Every time your line operator opens the fill door on the hot melt tank, the external air hits the existing glue and cools it off. Even if the lid on your tank is only open for a few minutes, that could impact not only the current glue in the tank reservoir, but the glue you are adding to the tank. If your glue pellets are colder than normal, it will take a longer amount of time to heat them.
Another important task would be to inspect your system setup for any cold joints. A cold joint would be any unnecessary extensions that you have added throughout the adhesive application process. Most cold joints are found on older machines that use larger sized extensions and filter housings. The more cold joints on the system, the more inconsistent the glue will heat and stay heated throughout the entire application process.
If your main problem is glue stringing in the colder months, an easy solution would be to shorten the distance from the nozzle tip to the top of the box. Limiting the amount of time the glue has to travel in the air will help to lessen the problem of stringing, which can cause a weakened seal on the box.
If you have any questions about how to reduce the impact of winter weather on your hot melt system, please reach out to a technical rep at firstname.lastname@example.org.