Air quality is important in all aspects of life, but for some reason usually overlooked in packaging lines. Almost all hot melt application equipment will require air to operate, especially if they are pneumatic. Universal Systems’ line of ProBilt™ hot melt equipment utilizes air in several different points of operation. The pneumatic pumps require air in order to shift the actuator and pump the glue through the system. Also, modules require air to open the piston and, in some cases, even to close the piston. Of the two operations in your hot melt application process that require air, it is most important for the pump to receive clean air.

Universal Systems pneumatic pumps are manufactured with extreme precision and delicacy. The most important part of the pump is the actuator, otherwise known as the shifter. The shifter’s main components are the spool and sleeve, which is how the shifter “shifts”. The spool and sleeve are machined in pairs, hand measured, calibrated, cleaned and assembled. The shifter is attached to the side of the pump. If you have a ProBilt™ tank and pump, take a look at the label on the side of the shifter. It reads: “The air supplied to the pump should be dry, filtered and non-lubricated.” If the air supplied to the pump, that goes through the shifter, is lubricated, your shifter will seize over time. The reason is that the oil in the air will build up in the millimeters of space between the shifter spool and sleeve, not allowing it to smoothly shift. If you do have unfiltered air running to your hot melt pump, we sell a ¼ NPT filter regulator that you can attached to the air lines and filter the air before it goes into the pump. Check it out on our website here.

If you have any questions regarding your pneumatic pump or modules, please call us at (561) 272-5442 and one of Universal Systems’ technicians will be happy to help. You can also email sales@ussefl.com.