As we head into the New Year and the weather gets colder, you may be experiencing inconsistencies with the adhesives on your packaging lines. What most line operators and maintenance managers do not realize is that the location of your packaging line in the plant can play a large role in the dependability of your adhesive.
This time of year, we receive several troubleshooting calls regarding hot melt consistency, heated hose and gun temperature consistency and glue stringing. It is important to take the external environment into consideration when attempting the first step in troubleshooting some of these problems. One of the first questions to ask is: where is your packaging line located? For example, if it is at the end of the packaging process, which it most likely is, then it might be on the exterior wall of your plant. Or it might be near an external door or window. If it is on the outskirts of the plant facility, and you are located in a part of the United States that is cold in the winter, then the outside temperature could be impacting not only the viscosity of your glue, but the heating time of your glue and its adhesion ability.
Every time your line operator opens the fill door on the hot melt tank, the external air hits the existing glue and cools it off. Even if the lid on your tank is only open for a few minutes, that could impact not only the current glue in the tank reservoir, but the glue you are adding to the tank. Especially if you are adding in cold glue. If your glue pellets are colder than normal, it will take a longer amount of time to heat them. A solution to this issue would be to invest in an auto-fill hot melt application system. Universal Systems SE manufactures the ProBilt™ Phoenix Auto-Fill Application System. Not only will this system help in the winter months, it helps all year long by drastically reducing the number of times your line operator needs to add glue pellets.
Another important task would be to inspect your system setup for any cold joints. A cold joint would be any unnecessary extensions that you have added throughout the adhesive application process. Most cold joints are found on older machines that used larger sized extensions and filter housings. For example, the older gun filter assemblies had larger filter housings and longer extension joints, that are unnecessary and can inhibit the consistency of hot melt flow. The more cold joints on the system, the more inconsistent the glue will heat and stay heated throughout the entire application process.
If your main problem is glue stringing in the colder months, an easy solution would be to shorten the distance from the nozzle tip to the top of the box. Limiting the amount of time the glue has to travel in the air will help to lessen the problem of stringing, which can cause a weakened seal on the box.
For any further information on the ProBilt™ Phoenix Auto-Fill Application System, or to speak to a technician about any troubleshooting of your adhesive application system, please call Universal Systems SE at (800) 848-5018 or email sales@ussefl.com.